2-46
46 | Handling Paper and Other Media
9. Make sure the paper you are creating the configuration for is loaded in
the correct paper path in the printer. Then press r and Enter to
print a paper thickness pattern. The printer prints a pattern similar to
the following:
10. Examine the printed pattern for the most evenly overlapping lines, and
choose that pattern number. (In the example shown above, the lines of
pattern 4 are the most even.)
11. After printing the pattern,
THICKNESS NUMBER is displayed. Press d
or u to select the number that you noted in step 7. Then press
Enter
to save the setting.
12. Press l and then d to select
PAPER FEED ADJUST A, then press r.
Adjusting this setting and the
PAPER FEED ADJUST B can help
eliminate banding.
13. Press u or d to set the paper feed
amount for the printable area (labelled
A
in the illustration), and then
press Enter. Choose a lower value if
you see white lines on your prints, or a
higher value if you see dark lines.
14. Press l and then d to select
PAPER FEED ADJUST B, then press r.
Smallest gap
sp3800Guide.book Page 46 Monday, January 29, 2007 11:08 AM
To Next Page
Loading...
