Epson Stylus Office T1100 - 4.4.10 Waste Ink Pad; Waste Ink Tray Assy

WorkForce 1100/Epson Stylus Office T1110/B1100/T1100/Epson ME Office 1100 Revision A
Disassembly And Assembly Disassembling the Printer Mechanism 104
Confidential
4.4.10 Waste Ink Pad / Waste Ink Tray Assy
1. Remove the Printer Mechanism. (Refer to 4.4.4 Lower Housing / Printer
Mechanism (p.86).)
2. Peel off the Pad Stopper Sheet from the Lower Housing.
3. Remove the four Waste Ink Pads from the sections indicated with A to D of the
Lower Housing.
Figure 4-101. Removing the Waste Ink Pad
4. Release the tab that secure the Waste Ink Tray Assy, and remove the Waste Ink
Tray Assy from the Lower Housing.
Figure 4-103. Removing the Waste Ink Tray Assy
 Attach the Pad Stopper Sheet as shown below.
Figure 4-102. Reinstalling the Pad Stopper Sheet
 Referring to Figure 4-101, correctly attach the four Waste Ink
Pads.
A
B
D
C
Pad Stopper Sheet
23mm ± 5mm
Pad Stopper Sheet
 Install the Waste Ink Tray Assy under the rib of the Lower
Housing.
 Route the Waste Ink Tube through the three grooves of the
Lower Housing.
Figure 4-104. Routing the Waste Ink Tube
Waste Ink Tray Assy
Rib Tab
Lower Housing
Waste Ink Tube
Lower Housing
Groove
www.printerwhy.net
高速行式打印机 http://www.lineprinter.com.cn/
_______________________________________________________________________________________
_______________________________________________________________________________________
打印机维修论坛 http://www.printerwhy.net/ 打印机驱动下载 http://www.printerwhy.com/