Epson Stylus Office T1100 - 5.2.3 Bi-D adjustment

WorkForce 1100/Epson Stylus Office T1110/B1100/T1100/Epson ME Office 1100 Revision A
Adjustment Adjustment Using Adjustment Program 138
Confidential
5.2.3 Bi-D adjustment
The pattern shown below is printed for each of the PG settings.
Figure 5-3. Bi-D Adjustment Printout Pattern
How to Judge
Examine the printout patterns for each of the five modes, and enter the value for the
pattern with no gap and overlap for each mode.
Additional information
If no OK pattern is printed, enter the value for the best one, and print the adjustment
pattern again.
C H E C K
P O I N T
Example for judgement
+0 +1 +2 +3 +4
OK NGNG
Overlap
Gap
www.printerwhy.net
高速行式打印机 http://www.lineprinter.com.cn/
_______________________________________________________________________________________
_______________________________________________________________________________________
打印机维修论坛 http://www.printerwhy.net/ 打印机驱动下载 http://www.printerwhy.com/