Epson Stylus Office T1100 - 4.2.7 Upper Housing; Printer Cover

WorkForce 1100/Epson Stylus Office T1110/B1100/T1100/Epson ME Office 1100 Revision A
Disassembly And Assembly Removing the Housings 72
Confidential
4.2.7 Upper Housing / Printer Cover
1. Remove the Decoration Plate Left/Right. (p.71)
2. Remove the Panel Unit. (p.69)
3. Remove the seven C.B.P. M3 x 10 screws that secure the Upper Housing.
4. Remove the Upper Housing while pulling out the Panel FFC through the cutout of
the Upper Housing.
Figure 4-15. Remove the Upper Housing
1) C.B.P. M3x10
(6±1 kgf.cm)
6
1) C.B.P. M3x10
(6±1 kgf.cm)
7
1) C.B.P. M3x10
(6±1 kgf.cm)
5
2
1) C.B.P. M3x10
(6±1 kgf.cm)
1
3
1) C.B.P. M3x10
(6±1 kgf.cm)
4
Upper Housing
 Route the Panel FFC correctly as shown in Figure 4-12.
 Install the Upper Housing so that the Grounding Plate properly
protrudes through the cutout of the Upper Housing.
Figure 4-16. Routing the Panel FFC
 Tighten the screws in the order shown in Figure 4-15.
A D J U S T M E N T
R E Q U I R E D
After replacing the following parts, be sure to apply G-74 grease to the
area specified for each part.
 Upper Housing: See Figure 6-14 on page 158.
Upper Housing
Grounding Plate
www.printerwhy.net
高速行式打印机 http://www.lineprinter.com.cn/
_______________________________________________________________________________________
_______________________________________________________________________________________
打印机维修论坛 http://www.printerwhy.net/ 打印机驱动下载 http://www.printerwhy.com/