Epson Stylus Office T1100 - 4.4.13 Ink System Unit

WorkForce 1100/Epson Stylus Office T1110/B1100/T1100/Epson ME Office 1100 Revision A
Disassembly And Assembly Disassembling the Printer Mechanism 107
Confidential
4.4.13 Ink System Unit
1. Remove the Paper EJ Frame Assy. (p.106)
2. Release the Carriage Lock, and move the Carriage Unit to the center. (Refer to 4.1.5
Locking/Releasing the Carriage (p.65).)
3. Release the two tabs that secure the clamps to the Upper Shield Plate, and remove
the two clamps.
4. Disconnect the Pump Motor cable from the connector CN117 on the Main Board.
5. Remove the Pump Motor cable from the Cord Keep.
Figure 4-109. Removing the Pump Motor cable
 Hook both rear ends of the Paper EJ Frame Assy onto the tabs
on the Main Frame.
Figure 4-108. Reinstalling the Paper EJ Frame Assy
 Align the tabs with the five positioning holes.
See Figure 4-106 (p.106)
 Tighten the screws in the order shown in Figure 4-106
A D J U S T M E N T
R E Q U I R E D
After replacing or removing the Paper EJ Frame Assy, always make
the required adjustments referring to the following.
• “Chapter 5 Adjustment (p.128)”
Tabs
 Referring to Figure 4-147, attach two pieces of acetate tape to
the frame.
 Referring to Figure 4-148, route the Pump Motor cable, the
Relay connector cable and the CR Motor connector cable.
CN117
Main Board
Pump Motor cable
Clamps
Cord Keep
Tabs
www.printerwhy.net
高速行式打印机 http://www.lineprinter.com.cn/
_______________________________________________________________________________________
_______________________________________________________________________________________
打印机维修论坛 http://www.printerwhy.net/ 打印机驱动下载 http://www.printerwhy.com/