Epson Stylus Photo - Connecting the Printer to Your Macintosh

Connecting the Printer to Your Macintosh
To use the printer’s built-in serial interface, you will need
an Apple System Peripheral-8 cable. Read the following steps
to connect the printer to your Macintosh.
1. Make sure both your printer and Macintosh are switched off.
2. Connect one end of the interface cable to the serial connector
on the back of the printer.
Note:
Use only an Apple System Peripheral-8 cable to connect the
printer to your Macintosh. Do not use a LocalTalk cable.
3. Connect the other end of the interface cable to either the
modem port or printer port on the Macintosh. The ports are
marked with the following icons. (Some Macintosh Power
Book models have only one serial port.)
Note:
If your Macintosh has a built-in modem, connect the interface
cable to the printer port.
C-14
modem port
printer port
em-17,18
L EPSON Stylus Photo
User’s Guide
A5 size Chapter 2
12-28-96
2-20 Getting Started