1-4
1-4 | Setting Up the Printer
3. Assemble the other leg and base in the
same way.
4. Attach the bottom support bar as shown. Fasten the bar with one
collar (J) and one bolt (I) at each end.
5. Attach the top support bar as shown. Use a Phillips screwdriver to fasten
the four small screws (K).
6. Make sure each part of the stand is tightened securely.
H
J
K
K
K
Printer Guide.book Page 4 Monday, April 22, 2002 3:02 PM
To Next Page
Loading...
