203
LCD screen message Condition/solution
Communication between the
network and the printer is
unstable.
You may be able to resolve this
by setting IEEE802.3az (Energy
Efficient Ethernet) to "Off".
See your documentation for
details.
See the links below or contact your network administrator for more
details.
The initial password is the
product's serial number.
Please check the serial number.
For more details, please refer to
the user manual.
See the link below for more details.
The initial password is provided
on the label attached to the
product.
For more details, please refer to
the user manual.
Recovery Mode The printer restarted in recovery mode because the firmware update
failed. Make sure you downloaded the latest firmware from the
Epson website and that the computer and printer are connected via
USB. Then try updating the firmware again.
A printer part needs to be
replaced
Contact Epson Support. For
details, see your documentation.
XXXXXXXX
(maintenance request code)
A part used in the printer is nearing the end of its service life. Contact
Epson for support and provide them with the displayed maintenance
request code. The error persists until you replace the requested part.
If you continue to use the printer, a printer error will occur.
To Next Page
Loading...
