55
6. Set the paper settings for the roll paper you loaded.
Note: The output tray can only hold one sheet of roll paper at a time. Remove each sheet as it is
ejected without letting the sheets stack up on the output tray. Do not allow cut sheets and roll paper
to stack up together.
Parent topic: Roll Paper Handling
Related references
Available Epson Papers
Paper Specifications
Roll Paper Options - Windows
Related tasks
Selecting Roll Paper Settings - Mac
Removing Roll Paper
Cutting Roll Paper
The printer has a built-in cutter that can automatically cut most paper types or you can cut your prints
manually. When Auto Cut is turned on, paper is automatically cut after each page prints, or if the roll
paper leading edge is not straight.
To switch between automatic or manual cutting methods, select Menu > General Settings > Printer
Settings > Paper Source Settings > Roll Paper Setup > Cut Settings > Auto Cut on the control panel
or adjust the auto cut settings in the printer driver. The setting selected in the printer driver overrides the
control panel setting.
Caution: Do not use the built-in cutter with these paper types or you may damage or dull the blade:
• Fine art paper
• Canvas
• Matte poster board
When you print on these paper types, you need to disable the Auto Cut setting and cut the print
manually. You can print cutting guidelines to help you.
Note: If the Quick Cut setting is enabled, the top area may become slightly uneven depending on the
image since the print stops while the leading edge of the roll paper is cut. If you do not want to have an
uneven leading edge, disable Quick Cut.
To Next Page
Loading...
