32
Note: The network name and password are case sensitive. Be sure to correctly enter uppercase and
lowercase letters, and numeric or special characters.
• To move the cursor, press the left or right arrows.
• To enter numbers or symbols, select 123#.
• To change the case of letters, select .
• To delete the previous character, select .
• To enter a space, select Space.
6. Select OK when you finish entering your password.
7. Confirm the displayed network settings and select Start Setup to save them.
A message appears when setup is complete.
8. Do one of the following:
• If setup was successful, select Close to exit or wait for the message to disappear.
• If setup was unsuccessful, select Print Check Report to print a network setup report or Re-enter
to re-enter your network name and password.
9. Press the home button to exit.
You see the Wi-Fi icon on the LCD screen and should be able to connect to your product directly
from your computer or device, and then print. If you are printing from a computer, make sure you
installed the network software from the Epson website.
Note: If you don't see the Wi-Fi icon, you may have selected the wrong network name or entered
the password incorrectly. Repeat these steps to try again.
Parent topic: Wi-Fi Infrastructure Mode Setup
To Next Page
Loading...
