6-3 Commands
HT
Name
Format
Description
Notes
Reference
LF
Horizontal tab
< 09 >
H
Moves the print
• This command
position to the next horizontal tab position.
is ignored unless the next horizontal tab
position has been set.
• Horizontal tab positions are set by ESC D.
• The default horizontal tab positions are at intervals of 8
characters (9th column, 17th, 25th. . .) for the primary font.
• Since a half-dots cannot be used in Page Mode, a half-
dot shift may occur from the specified horizontal tab positions.
ESC D
Name
Print and line feed
Format
< 0A >
H
Description
Prints the data in the print buffer and performs 1 line feed
based on the current line spacing.
• Sets the print starting position to the beginning of the
line.
Reference
ESC 2, ESC 3
FF
Name
Print and eject cut sheet, or print and switch from Page
Mode to Standard Mode
Format
< 0C >
H
The following points differ in Standard Mode and Page Mode.
<Standard Mode>
Description
Prints the data in the print buffer and ejects a cut sheet.
-21-
To Next Page
Loading...
Need help?
General
