Epson TM-H6000V User Manual

24
English
Inserting Slip Paper
!CAUTION:
Models with an MICR reader use a permanent magnet. Do not bring a magnetic card or the like near the
product.
When printing on slip paper, follow the steps below to insert the paper.
If your printer is equipped with a MICR reader, MICR reading is available by inserting the check paper so
that the MICR characters on the paper are on the right side.
1. Make sure the printer is turned on.
2. Set the paper so that the right edge of the paper contacts the paper guide on the right and insert the slip
paper. Refer to the label affixed to the printer.
Inserting Validation Paper
If your printer is a validation model, insert the paper in the same way as normal slip paper (See "Inserting Slip
Paper" on page 24
) or follow the steps below.
1. Make sure the printer is turned on.
2. Insert the paper with the right paper edge against the right side of the paper guide at the printer top, and
insert it as far as it will go.
3. Insert the paper straight down until the bottom edge of the paper touches the stopper.

Epson TM-H6000V Specifications

General

Type	POS printer
Print technology	Thermal
Maximum resolution	180 x 180 DPI
USB connector	USB Type-A / USB Type-B
Serial interface	Yes
Standard interfaces	Ethernet, NFC, RS-232, USB 1.1, USB 2.0
Serial interface type	RS-232
Connectivity technology	Wired
Wi-Fi	-
Product color	Black
Sustainability certificates	ENERGY STAR
Storage temperature (T-T)	-10 - 50 °C
Operating temperature (T-T)	5 - 45 °C
Operating relative humidity (H-H)	10 - 90 %
Country of origin	China
Autocutter durability	3 million cuts
Pallet width	800 mm
Pallet height	780 mm
Pallet length	1200 mm
Pallet width (UK)	1000 mm
Quantity per pallet	56 pc(s)
Quantity per pallet (UK)	70 pc(s)
Quantity per pallet layer	8 pc(s)
Quantity per pallet layer (UK)	10 pc(s)
Package depth	384 mm
Package width	295 mm
Package height	289 mm
Package weight	6068 g
Quantity per pack	1 pc(s)
Maximum roll diameter	83 mm

Weight and Dimensions

Depth	278 mm
Width	186 mm
Height	181 mm