237
1 Translucent film
2 Print head rail
Caution: Do not touch the flat white cable or the print head rail; otherwise, you may not be able to
print. Do not wipe off the grease on the rail.
6. Moisten a cotton swab with the water and detergent mixture and squeeze out any excess moisture.
Use it to lightly wipe ink off the translucent film.
Caution: Do not press too hard on the film or you may dislocate the anchor springs and damage the
product.
7. Use a new, dry cotton swab to dry the translucent film.
8. Repeat steps 6 and 7 as necessary to clean all ink smears.
9. When the translucent film is dry, close the scanner unit.
10. Plug in the power cable and reconnect any interface cables.
Parent topic: Cleaning and Transporting Your Product
Related tasks
Cleaning the Paper Guide
Cleaning the Paper Rollers
Aligning the Print Head Using the Product Control Panel
To Next Page
Loading...
