175
Setting Options Description
Dial Tone Detection On Automatically dials the number you enter for faxing
when the product detects a dial tone.
Off Turns off automatic dial tone detection, which may
be necessary if the product is connected to a PBX
(Private Branch Exchange) or a TA (Terminal
Adapter). However, turning this setting off may cause
the product to drop the first digit of a fax number.
Line Type PSTN Selects a standard phone line (Public Switched
Telephone Network).
PBX Selects Private Branch Exchange, the type of phone
line used in office environments where an access
code such as 9 must be used to call an outside line.
Header Your Phone
Number
Select to enter your phone number and header
information for inclusion on outgoing faxes.
Fax Header
Receive Mode Manual Lets you confirm whether an incoming fax should be
printed; a telephone must be connected to the
product
Auto Automatically receives and prints faxes.
Distinctive Ring All If you are using a Distinctive Ring Service on your
phone line, your telephone company can assign two
or more phone numbers to the same line and assign
different ring patterns to each. If you use this service,
select the number of rings for your fax number so
your product can receive faxes on the correct
number of rings. Select All for phones lines that do
not use this service.
Single
Double
Triple
Double&Triple
Rings to Answer 1 to 9 Sets the number of rings before your product
receives a fax. If Receive Mode is set to Auto and an
answering machine is connected to the product,
make sure this setting is set higher than the number
of rings your answering machine is set to answer a
call.
To Next Page
Loading...
Need help?
General
