1. Hold the authentication card over the card reader.
e
unregistered card settings message is displayed on the multi-function device’s control panel.
2. Click Ye s .
e screen for entering the user ID and password is displayed.
3. Enter the user ID and password on the control panel, and then select the domain.
Select the Domain from the following.
For users that are managed by an LDAP server: LDAP server domain name
For users that are managed by Epson Print Admin : (Local)
Contact your system administrator for more information on each item.
4. Press Register.
e registration completion message is displayed.
5. Hold the authentication card over the authentication device again to conrm the login.
When you login, the Full name is displayed automatically at the top right of the menu.
6. Press Log out to log out.
Note:
❏ Registering a temporary card
If you have lost the authentication card that was registered in the authentication system, you can register a
temporary card. e registration method is the same as for the authentication card. A temporary card is valid only
during the period set by the system administrator. Contact your system administrator for more information.
You can check if the temporary card is registered in the user information.
❏ Updating an authentication card
If your system administrator has allowed it, you can update the authentication card.
Hold your new card and enter your user ID and password. Select the replacement card from the displayed menu to
update the registered card.
User's Guide
Preparing for Use
18
To Next Page
Loading...
