Epson WorkForce 545 User Manual

Cannot Print Over a Network
If you cannot print over a network, try these solutions:
• Make sure that your product is turned on.
• Make sure you install your product's network software as described in your product documentation.
• Print a network status sheet and verify that the network settings are correct. If the network status is
Disconnected, check any cable connections and turn your product off and then on again.
• If you are using TCP/IP, make sure the product's IP address is set correctly for your network. If your
network does not assign IP addresses using DHCP, set the IP address manually.
• Make sure your computer and product are both using the same wireless network.
• Check your wired LAN router or access point to see if the LED for the port to which your product is
connected is on or flashing. If the link LED is off, try the following:
• Make sure the Ethernet cable is securely connected to your product and to your router, access
point, switch, or hub.
• Try connecting your product to a different port or a different router, access point, switch, or hub.
• Try connecting with a different Ethernet cable.
• Try printing to your product from another computer on the network.
• If network printing is slow, print a network status sheet and check the signal strength. If it is poor, place
your product closer to your router or access point.
Note: Avoid placing your product near a microwave oven, 2.4 GHz cordless phone, or large metal
object, such as a filing cabinet.
• If you are connecting the product via EpsonNet Setup and the WiFi light on your product is not solid
green, make sure your product software was installed correctly. If necessary, reinstall your software.
Parent topic: Solving Network Problems
Related tasks
Printing a Network Status Sheet
Cannot Scan Over a Network
If you cannot start Epson Scan for scanning over a network, try these solutions:
• If you are scanning a large original at a high resolution, a network communication error may occur. Try
scanning again at a lower resolution.
276

Epson WorkForce 545 Specifications

Print Specifications

maximum print resolution	5760 x 1440 optimized dpi
ISO print speed black	15 ISO ppm
ISO print speed color	7.2 ISO ppm

Copy Specifications

maximum copy size	8.5" x 14"
ISO copy speed black	12 ISO cpm
ISO copy speed color	5.5 ISO cpm

Scan Specifications

optical resolution	2400 dpi
hardware resolution	2400 x 2400 dpi
maximum resolution	9600 x 9600 dpi

Fax Specifications

modem speed	33.6 Kbps
fax memory	up to 180 pages
speed dials	60 (max.)

Power Specifications

rated voltage	100 – 120 VAC
rated frequency	50 – 60 Hz
rated current	0.6 Amp

Operating Environment

operating temperature	50 ° to 95 °F (10 ° to 35 °C)
storage temperature	-4 ° to 104 °F (-20 ° to 40 °C)
operating relative humidity	20 – 80%

Weight and Dimensions

printing dimensions (W x D x H)	17.6" x 21.9" x 9.4"
storage dimensions (W x D x H)	17.6" x 14.2" x 8.9"
weight	17.6 lb