Wireless MCU function setting code
Inventory function Settings
Ordinary mode
(Immediate upload of data)
%%ALLPT-SET
Inventory mode
(The storage mode)
%%ALLMEM-SET
Data is not missing from the
mode
(Instant upload of data +
storage mode)
%%ALLAEM-SET
The total number of scans is
shown
(Inventory mode is
applicable)
%%ALLMEM-ZS
clear data
(Use with caution)
%%ALLMEM-QC
explain:
1． Normal mode: scan the bar code into the normal mode, and in this mode, the scan results
will be uploaded to the computer in time (this mode is the default mode).
2． Inventory mode: Scan the bar code into the inventory mode, in which the scan results
will be stored in the internal memory (when the internal memory is occupied, the buzzer
will "tick" 3 times to prompt).
3． Data loss mode: scan the bar code into data loss mode. In this mode, the data is uploaded
to the computer and saved to internal storage.
4． Data upload: scanning the barcode can upload the data stored in the internal memory
to the computer in turn (applicable in inventory mode and data loss mode, please ensure
the wireless signal is normal when uploading the buzzer will "tick" 1 time after successful
data upload, and the buzzer will "tick" 3 times).
5． Display the total number of scans: scanning the barcode shows the total number of stored
data (inventory mode applies).
6． Clear data: Scanning this barcode removes all the data from the internal memory.
To Next Page
Loading...