ESAB EPP-362 - INSTALLATION; 3.0 Installation

19
SECTION 3 INSTALLATION
3.1 General
FAILURE TO FOLLOW INSTRUCTIONS COULD LEAD TO DEATH, IN
JURY OR DAMAGED PROPERTY. FOLLOW THESE INSTRUCTIONS
TO PREVENT INJURY OR PROPERTY DAMAGE. YOU MUST COM
PLY WITH LOCAL, STATE AND NATIONAL ELECTRICAL AND SAFETY
CODES.
WARNING
3.2 Unpacking
• Inspect for transit damage immediately upon receipt.
• Remove all components from shipping container and check for loose parts in container.
• Inspect louvers for air obstructions.
3.3 Placement
• A minimum of 1 meter (3 feet) clearance on front and back for cooling air ow.
• Plan for top panel and side panels having to be removed for maintenance, cleaning and inspection.
• Locate the plasma unit relatively close to a properly fused electrical power supply.
• Keep area beneath power source clear for cooling air ow.
• Environment should be relatively free of dust, fumes and excessive heat. These factors will aect
cooling eciency.
Conductive dust and dirt inside power source may cause arc ash-
over. Equipment damage may occur. Electrical shorting may occur if
dust is allowed to build-up inside power source.
See maintenance section.
CAUTION
3.0 Installation