3
・
To Monitor Alarm Log .................................................................30
・
To Monitor Power ON/OFF Status and Key Lock Status............31
・
To Monitor Key Lock Status........................................................31
・
To Monitor Communication Error Log.........................................32
・
To Monitor Chamber Pressure (Only when equipped with
optional temperature, humidity and pressure recorder)............32
3.3 Setting Commands .....................................................................33
・
To Switch to the Constant Mode.................................................33
・
To Switch to the Constant Mode.................................................33
・
To Switch to the Program Mode .................................................33
・
To Set the Control Mode.............................................................34
・
To Set Constant Mode Pattern No..............................................34
・
To Set Constant Mode Parameters ............................................34
・
To Set Constant Mode Time.......................................................35
・
To Set Program Mode Pattern No. .............................................35
・
To Set Program Mode Step No...................................................35
・
To Set Up Program Mode Patterns.............................................36
・
To Set the Auto Start Timer........................................................37
・
To Start Operations ....................................................................37
・
To End Operations at Cycle End ................................................38
・
To End Operations Immediately .................................................38
・
To Lock/Unlock Keys..................................................................39
・
To Clear the Communication Error Log ......................................39
Chapter 4 Example Applications
4.1 To Monitor Chamber Control Status from Computer ..................42
4.2 To Edit Test Setup from Computer .............................................43
Chapter 5 Specifications
5.1 Specifications ..............................................................................46
About RS-485 Communications ...................................................46
・
RS-485 signal assignment..........................................................46
・
About RS-485 Specifications......................................................46
・
Documents configuration............................................................47
To Next Page
Loading...
