Contents
Introduction
Chapter 1 Overview
1.1 Communication Function ..............................................................6
・
RS-485 ........................................................................................6
1.2 Communication Interface ..............................................................7
・
RS-485 ........................................................................................7
1.3 Transmitted Data ..........................................................................8
・
Types of Data ..............................................................................8
・
Data Format ................................................................................9
・
Error Messages .........................................................................10
1.4 Data Transfer ..............................................................................11
Chapter 2 Communication Setup
2.1 Communication Setup ..................................................................16
・
How to Change Communication Settings ...................................16
Chapter 3 Commands
3.1 Command List .............................................................................20
3.2 Monitor Commands ....................................................................22
・
To Monitor Chamber Conditions.................................................22
・
To Monitor Chamber Model and ROM Version...........................22
・
To Monitor Humidifying Water Target and Monitored
Temperatures ...........................................................................23
・
To Monitor Current Chamber Process........................................23
・
To Monitor Door Lock Status......................................................24
・
To Monitor Time Signal Output...................................................24
・
To Monitor Operating Mode Setting............................................25
・
To Monitor Control Mode Setting................................................25
・
To Monitor Constant Mode Pattern No. ......................................26
・
To Monitor Constant Mode Parameters......................................26
・
To Monitor Constant Mode Time Information..............................26
・
To Monitor Program Mode Pattern No........................................27
・
To Monitor Program Mode Current Step No. ..............................27
・
To Monitor Program Mode Setup................................................27
・
To Monitor Program Mode Pattern Total Time............................28
・
To Monitor Program Mode Total Time Information .....................28
・
To Monitor Auto Start Timer Information.....................................29
・
To Monitor 0.1 Hour Timer Time.................................................29
2
To Next Page
Loading...
Need help?
General
