Installation
Dip Switch Setup
The dip switch is behind the access door on the rear of the LSRA(-C).
Refer to Figure Chapter 3-10 and Table Chapter 3-3 for switch position
settings.
Annunciator Program
To put the annunciator in the program mode to download a program,
move S1-4 to the ON position and back to the OFF position. The
switch must be returned to the off position in order for the annunciator
to operate properly.
Password Program
To put the annunciator in the password program mode, set S1-3 to the
ON position and back to the OFF position. Enter a 5 digit password,
then re-enter it verify your entry. The switch must be returned to the
off position in order for the annunciator to operate properly.
Buzzer Disable/ Auto-Acknowledge Enable
Refer to Figure Chapter 3-10 and Table Chapter 3-3.
Table Chapter 3-3: Dip Switch Positions
Description Switch
S1-1
Switch
S1-2
Switch
S1-3
Switch
S1-4
Annunciator Programming Mode OFF OFF OFF ON*
Password Programming Mode OFF OFF ON* OFF
Buzzer Enabled and Auto-Acknowledge Disabled OFF OFF OFF OFF
Buzzer Disabled and Auto-Acknowledge Disabled OFF ON OFF OFF
Buzzer Enabled and Auto-Acknowledge Enabled ON OFF OFF OFF
Buzzer Disabled and Auto-Acknowledge Enabled ON ON OFF OFF
* = Toggle Switch On and Off
3.16
LSRA Installation, Operation, Maintenance, and Configuration Manual
To Next Page
Loading...