Normal message, that the count reaches a preset
value.
The current position of X-axis is out of the minimum
value, it is necessary to move the X-axis to the soft
limit range manually.
The current position of X-axis is out of the maximum
value, it is necessary to move the X-axis to the soft
limit range manually.
The current position of G-axis is out of the minimum
value, it is necessary to move the G-axis to the soft
limit range manually.
The current position of G-axis is out of the maximum
value, it is necessary to move the G-axis to the soft
limit range manually.
Move the cutter to the upper dead point by foot witch.
When the X-axis is employed for the front feed, The
current position of X-axis is out of the soft limit range,
it is necessary to move the X-axis to the soft limit
range manually.
The slider is not on the TDC in the case of positioning.
Move the cutter to the upper dead point by foot witch.
The count reaches the preset value, need to manually
clear alarm.
Need to start the pump power.
The voltage of encoder is abnormal, please check it.
Can communication is abnormal, please check
whether the communication port ground is well.
The X-axis driver is missing, need to power on system
and drive again.
The device is not connected to the drive, please
connect the drive.
Light signal loss on the CUT stage, check the screen
input signal with or without object light signal.
The system voltage is lower than the normal value,
check whether the system voltage is normal.
The X-axis CAN communication is abnormal,
restarting the system after clearing the alarm.
To Next Page
Loading...