8
Chapter 3 Operation Description
3.1 Tipwizard
3.1.1 Start and Stop
After finishing the programming, press to run the device.
The device starts, the green indicator light.
Only on the SINGLE page, PROAGRAM page or STEP page, the machine can run after
pressing . In other pages, press to run is invalid.
When there is any alarm, the machine cannot start until the alarm is clear, the machine
can start again.
Press to stop the machine immediately, at the same time, the page on the device
backs to the previous programming page.
The device does not start, the red indicator light.
3.1.2 Parameter Setting
When editing the parameter, press to select the parameter you
want to modify, input the value and press to finish.
When editing the parameter, please accord to the tip on the page to edit. If the value out
of range, the page will display Out of range, please input a correct value again.
3.1.3 Alarm Reset
When there is any alarm, the machine stops immediately. If you want to recover the
machine’s operation, you need to clear the alarm.
On the CONST page, press to enter the ALARM RECORD page, the most of top
is the recent alarm information. Please according to the information on the page to
processing the problem, and then press and to clear the alarm, finally you
can run the device.
3.1.4 Monitor
On the CONST page, press to enter IO MONITOR page.
ON the IO MONITOR page, press to enter YV MONITOR page.
To Next Page
Loading...