1
Preface
Synopsis
This document guides the operator how to operate the E200PS shear numerical control
device.
Chapter 1 describes panel and page.
Chapter 2 describes the example operation of the Single-Step and Multi-Step.
Chapter 3 describes the operation guide of the pages.
Intended Audience
This document is intended for the authorized and properly trained persons:
Device manufacturer: In the device production process, the people who diagnose the
device have the highest managing privileges.
System integrators: usually refers to the technical personnel of machine tool
manufacturers, who can configure the machine parameters to commissioning the
system.
Operator: use the machine to do the programming work, set the programming constant
parameters.
Attention
Copy right is preserved by ESTUN. It is not allowed to add or delete part or all of the
manual content without ESTUN’s consent. Do not use part or all of manual content for
the third party’s design.
E200PS device provides complete software control and has no mechanical protection
device for operator or the tool machine. Therefore, in case of malfunction, machine tool
must provide protection device for operator and external part of the machine tool.
ESTUN is not responsible for any direct or indirect losses caused by any operation of
the device.
ESTUN preserves the right to modifying this manual in the event of function adding or
print error.
E200PS device has the safety-door protection function, but only works on the CUT
stage, it is unavailable on others stage.
To Next Page
Loading...