Etatron DLX - Reset Procedure; Stand-by Procedure

• 43 •
EN
G
L
I
SH
7.5 - RESET PROCEDURE
Following is described the RESET procedure:
• Turn off and turn on the pump
• Press at the same time ESC and OK buttons until will appear the
revision
firmware (ex. 02.3.3) it will appear SETUP menu and the
default parameter start flashing
7.6 - STAND-BY PROCEDURE
With this procedure the pump is put on stand-by.
• Hold down key + and - until Stand-by appears on the display
• In order to exit this mode, hold down keys + and -.
DosingPump.ir