ETC ColorSource PAR - Pre-Configured Presets; Pre-Configured Sequences; Adjusting the Intensity of Presets

ETC Installation Guide
ColorSource PAR v1.5
ColorSource PAR v1.5 Page 7 of 12 ETC
Pre-configured presets
Pre-configured sequences
Adjusting the intensity of presets
1: Ensure that DMX data is not present.
2: Press the Mode button to access the Preset/Sequence menu, and then
press the Up and Down buttons to select the preset that you want to
edit.
3: Hold the Mode button for 3 seconds. The display shows : ## where
the number is an intensity level from
, or .
4: Press the Up and Down buttons to change the intensity level of the
preset in real time.
5: Press the Mode button to confirm your selection and return to the
Preset/Sequence menu.
The fixture will automatically return to the Preset/Sequence menu after
10 seconds of inactivity without saving edits to the preset intensity. This
cancels unsaved changes.
Preset Name Preset Name
1 3200K White 7 Magenta
2 5600K White 8 Yellow
3 Red 9 Orange
4 Green 10 Light Yellow
5 Blue 11 Light Blue
6 Cyan 12 Light Pink
Sequence Name
1 Rainbow Fast
2 Rainbow Slow
3Warm Colors Fast
4 Cool Colors Fast
5 Random