24
6 Battery Replacement
Receiver batteries have to be changed, when the symbols are vacant displayed.
Transmitter batteries have to be changed, when the symbols are displayed.
Disconnect the instrument from the mains and switch them off.
Open and remove battery case cover on instrument rear.
Remove used batteries
Insert new batteries by respecting the polarity
Close battery case
The instrument is now operational.
Prior to storage battery replacement, disconnect the instrument from any
connected test leads.
Reverse polarity of batteries may destroy the instrument. Furthermore, they
may explode or ignite
Only use batteries as described in the technical data section!
(One 9V battery , NEDA 1604, IE6F22.Power).
Never try to make contact between both battery cell poles, for example by
using a wire connection. The resulting short-circuit current is very high and
causes extreme heat. Danger of fire and explosion !
Please consider your environment when you dispose of your one-way batteries
or accumulators. They belong in a trash for hazardous waste. In most cases,
the batteries can be returned to their point of sale. Please, comply with the
respective valid regulation regarding the return, recycling and disposal of used
batteries and accumulators.
If an instrument is not used over an extended time period, the batteries must
be removed. Should the instrument be contaminated by leaking battery cells,
the instrument has to be returned for cleaning and inspection to the factory.
““
•
•
•
•
•
•
Note:
To Next Page
Loading...