2
1 International Safety Symbols
Warning: This symbol indicates that the operator must refer to an explanation
in the user manual to avoid personal injury or damage to the meter.
Caution! Risk of electric shock
Reference. Please use utmost attention.
Comply with EMC.
Read the user manual carefully before attempting to operate or service the meter.
The respective accident prevention regulations established by the associations
for electrical systems and equipment must be strictly met at all times.
This WARNING symbol indicates a potentially hazardous situation, which if
not avoided, could result in death or serious injury, or result damage to the
product.
This symbol advises the user that the terminal(s) so marked must not be
connected to a circuit point at which the voltage with respect to earth ground
exceeds (in this case)300 VAC or VDC.
Prior to any operation, ensure that connecting leads used and electronic load
are in perfect condition.
If the operator’s safety cannot be guaranteed, the instrument must be removed
from service and protected against use.
The Cable Locator may only be used on systems complying with the nominal
voltages indicated in the technical data section.
Prior to usage ensure perfect instrument function: we recommend to exclusively
connect the transmitter from the phase towards the neutral conductor.
If the RCD trips when connecting the sender, a fault current is already active
within the installation.
If the instrument is subjected to an extremely high electro-magnetic field, its
functioning ability may be impaired.
1 Safety Information.1
MAX
300V
To Next Page
Loading...