25809-02A
34 - Lamp and Grill Replacement
Removing/Replacing Main Lamps
After opening the grill, grasp a lamp at one end
and at the middle and turn the lamp one quarter
turn. Gently remove the lamp from its holders.
Reinstall the lamp by inserting the pins located on
the ends of the lamp into the slots on top of the
lamp holders and turn the lamp a quarter turn. It
should click in place.
Removing/Replacing Main Lamp Starters
The top of the starter is visible after removing a
lamp. There is one starter for each lamp. Grasp the
starter and turn it gently. It will click loose and pull
out easily.
Reinstall the starter by inserting the pins located
on the bottom of the starter into the holes in the
starter holder and turning. It should click in place.
Recommended Replacement Lamps
We recommend using the lamps specified below.
Use of uncertified lamps is a violation of Federal
regulations and will void your warranty. These
lamps have an average life of 600-800 hours of
effective tanning use. Lamps used longer than that
begin to lose their effectiveness even though they
continue to light.
ONLY THE FOLLOWING LAMPS HAVE BEEN CERTIFIED FOR USE IN THIS EQUIPMENT:
BRONZING SUN™ Wolff® Model BS71-T12-160W VS-R BI-PIN
To Next Page
Loading...
