25809-02A
Troubleshooting - 37
Problem Solution
I forgot what address I set
my sunbed to
Timer display changes to
indicate a tanning time
after the START button is
pressed but lamps do not
come on
My bed is connected to the
T-Max® Manager remote
system and when the delay
time has expired the timer
display starts counting
down but the booth lights
do not come on
My booth won’t work with
the T-Max® Manager
remote system
I frequently disconnect my
sunbeds from the T-Max®
chain and interrupt the rest
of the units
Timer display continues to
show 0:00 after the START
button is pressed
By holding the STOP button for 3 seconds the
timer display will briefly blink “id” and your
address number.
1. See Electrical Connections.
2. See Electrical Connections.
3. If remote is being used, other than T-Max®
Manager, the external timer may not be acti-
vated.
4. See the instructions provided with the remote
interface kit.
The auto start feature of the remote system is
disabled, see the instructions provided with
your remote system.
1. The booth must first be set to a unique
address, see Remote Connections.
2. The bypass or terminator plug may be
installed in the series in an inappropriate
location. Plug the bypass plug only into the
bed at the end of the series.
A T-Max® Inline 4-Pin Connector is available
from ETS, Inc. which connects the chain with-
out a sunbed.
1. T-Max® Manager remote system has not yet
been set.
2. Booth address is not set correctly, see Remote
Connections.
Cause
1. Bypass plug not
installed
2. A non-SunStar®
bypass has been
used
3. Remote not set
4. Remote wiring
incorrect
Auto-start not on
1. Address incorrect
2. Terminator plug
installed incorrectly
To Next Page
Loading...
