26868-01A
21
Care and Maintenance - Lamp and Acrylic Replacement
Lamp and Acrylic Replacement
Introduction
To be assured of maximum tanning effec-
tiveness, change lamps after approximate-
ly 800-1000 hours of use. Tanning will
continue after this time but at a slower
rate. To ensure trouble-free operation of
your sunbed, replace the lamp starters
whenever the lamps are replaced.
Opening/Replacing Acrylic Shields
The acrylic shields are secured in place by
turn latches along the front edge. Use a
flat-bladed screwdriver to turn the latches
a quarter turn to open the acrylic. The
acrylics swing open on a hinge. On the
inside of the bench, along the front, are
two supports for the bench acrylic. Swing
them up to hold the bench acrylic open.
Both acrylics may be removed by lifting
them out of the channel along the back
edge.
When you are finished, simply reverse the
above directions to secure the acrylic
shields.
WARNING
Shock hazard.
Disconnect power before removing
any protective covers.
CAUTION
Be careful. The edges of the acrylic shield
may be sharp.
To Next Page
Loading...
