26868-01A
1
nstallation
Unpacking and Inspection
Your sunbed comes in two cardboard car-
tons, one for the canopy and one for the
bench and ballast tray. Open the cartons
and remove the sunbed parts as follows.
The boxes dismantle to allow easy
removal of the units. Remove the box tops
and pull the sides out. The bench and
canopy are each wrapped in plastic.
Remove the plastic and, with a helper or
two, grasp the canopy and pull it from the
carton bottom without using the plastic
endcaps to lift the unit. Do the same for
the bench. Do not attempt to lift either
unit with the plastic still on as it may slip.
The ballast drawer is secured to the carton
bottom with brackets. Remove these
brackets from the ballast drawer with a
Phillips screwdriver.
Note! The cartons are reusable. You may
wish to save them for future use.
After unpacking the unit, check to make
sure you have received the following:
• Canopy unit
• Bench unit
• Ballast drawer
• Body fan kit
• Pair of gas springs
• (2) endcaps (one with slots for the
body fan bracket)
• Front access panel
• Bag containing necessary assembly
hardware, safety goggles, and pillow
Inspect these items, including the canopy
and bench, and make sure they are free
from any visible damage. Report the
extent of any damage to the transportation
company.
Record the serial numbers of the canopy
and bench in the area provided at the
back of this manual. This information will
be required whenever you call customer
service.
To Next Page
Loading...
