26868-01A
Record this information for ease of service:
Date of purchase:
Bench serial number:
Canopy serial number:
Parts List
This is a list of parts which may be replaced by the
consumer. Care should be taken when replacing
anything related to electrical wiring. We recom-
mend contacting a professional electrician. When
calling for parts, first state your bed model as P-
332ST-3F. Then refer to this list and preceding
illustrations for proper part identification.
Access Panel
Access Panel Key*
Acrylic, Bench
Acrylic, Canopy*
Acrylic Edge Trim, Canopy*
Acrylic Protector Strip*
(on bench support rail)
Ballast, 100W
Ballast, Face Tanner 400W
Bearing, Nylon Floating*
Bushing, Bronze 10mm*
Canopy Mounting Arm
Capacitor, 1µF
Capacitor, 75µF
Contactor
Contactor for Face Tanner
Cover, Canopy*
Current Sensor
Endcap
Endcap, Canopy Head End
Endcap, with Body Fan Cut-outs
Face Tanner Assembly, Center*
Face Tanner Assembly, Outer*
Fan, Body
Fan, 4”
Fan Grill, Plastic*
Filter*
Gas Springs*
Hardware Kit, Complete*
Hardware Kit, Assembly*
Hour Counter*
Ignitor
Label, English Warnings
Label, French Warnings
Lamp Holder w/ Starter
Lamp Holder w/o Starter
Lamp Holder, Face Tanner*
Lamps*
Manual*
Paint, Champagne Touch-up*
Pillow*
Relay
Remote Connection PCB
Remote Control Bypass Plug*
Schematic Packet*
Starter, K-12
(main lamps)
Support, Bench Acrylic*
Thermostat*
(for face tanner)
Timer
Timer Interlink PCB
Timer Keypad
Timer Keypad Pushbuttons*
Trim Profile
(grey)
Wiring Harness, Keypad Link
Wiring Harness, Remote PCB to Timer
Wiring Harness, Timer in Tray
Wiring Harness, RJ-11 Canopy to Tray*
* Not shown
To Next Page
Loading...
