Evco EV3 CHIL User Manual

EVCO S.p.A.
7.2 Hydraulic pump
7.2.1 Initial information
The functional mode of the hydraulic pum
p
switched on for thermoregulation in relation
t
In the second case, the pump switches off a
f
by the regulator or switched OFF manually
f
pump to be stopped, as for the flow alarm in
on).
7.2.2 Function modes
The hydraulic pump can be set to function in
Continuous The pump is always i
n
On-call The pump is switche
d
delay (PM01) from
compressor is switch
e
7.2.3 Antifreeze function
When the temperature of the input or output
switches off when the temperature rises ab
o
(PM05), as shown below.
EV3 CHIL & EVD CHIL | Installer man
u
page 33 of 46
p
can be set using parameter Pm03: the pump may be al
w
t
o the functioning of the compressor.
f
ter a delay of PM02 from when the compressor is switched
o
f
rom the remote controller. It will switch off immediately if
a
manual re-arm (with the flow alarm active in automatic re-
a
two modes.
n
ON mode if PM03 = 0
d
on at the request of the heat regulator if PM03 = 1.
T
he
c
pump switch-on and the pump is switched off with a d
e
d off, as shown below:
water is below PM04, the pump is activated automatically if
o
ve the value of the antifreeze set-point (PM04), to which
m
u
al ver. 1.2 | Code 1443DCHILE124
w
ays kept switched on or be
o
ff every time it is deactivated
a
n alarm sounds requiring the
a
rm, the pump stays switched
c
ompressor is activated with a
elay (PM02) from when the
it was switched off. The pump
m
ust be added the hysteresis

Evco EV3 CHIL Specifications

General

Brand	Evco
Model	EV3 CHIL
Category	Controller
Language	English