Evco EV3 CHIL User Manual

EVCO S.p.A. EV3 CHIL & EVD CHIL | Installer manual ver. 1.2 | Code 1443DCHILE124
page 8 of 46
2.2 Description of EVD CHIL
The picture below shows the layout of the EVD CHIL.
The table below describes each part of the EVD CHIL.
PART DESCRIPTION
1
Male Micro-Fit connector for cabling for analogue inputs, digital inputs, analogue outputs and the open collector digital
output (for future reference, the digital output OC1)
2 Micro-switch for the termination of the RS-485 MODBUS port
3 If fitted, plug-in screw terminal block for the RS-485 MODBUS port cabling
4 Plug-in screw terminal block for cabling for the powered INTRABUS port
5
Plug-in screw terminal block for cabling for the digital outputs with electro-mechanical relay (for future reference, the
digital outputs DO1 and DO2)
6
Plug-in screw terminal block for cabling for the power supply, electrical-mechanical relay digital outputs (for future
reference, the digital outputs DO3 and DO4)
For more information see subsequent sections.

Evco EV3 CHIL Specifications

General

Brand	Evco
Model	EV3 CHIL
Category	Controller
Language	English