EVCO S.p.A. EVJ800 | Installer manual ver. 2.0 | Code 144J800E204
page 9 of 50
3 OPERATING THE DEVICE
3.1 Initial switch-on
Connect the device to the power supply: a neutral system loading screen will be presented:
Once loading is complete, the device will display the mode it was in before being powered down:
- on the Home screen with no power failure message;
- carrying out a cycle with the POWER FAILURE message indicating that there had been a loss of power.
3.2 Power failure
If there is a power failure with no function in progress, when power is restored the device will return to the mode set
before the failure occurred.
If the power supply fails while a function is active, when power is restored the device will behave as follows:
- if blast chilling or blast freezing was in progress, the cycle will resume, taking into account the duration of the power
failure;
- if a conservation cycle was running, the cycle will continue using the same settings.
If the power supply has been cut off long enough to cause a clock error (RTC code), it will be necessary to reset the
date and time.
3.3 Silencing the buzzer
To silence the buzzer touch any key while it is sounding.
To Next Page
Loading...
