Evenflo Embrace - Releasing the Carrier from the Base

Move the handle  to the “carry” position by
squeezing in on both handle releases  and rotating
the handle until it locks into place above the carrier.
Squeeze the carrier release handle  while lifting up
the carrier.



1
Releasing the Carrier from the Base
8
Move the handle to the “car” position by squeezing
both handle releases  and rotating the handle until
it locks into place behind the carrier.
Ensure there is at least 38 mm (1.5 inches) of space
between any part of the carrier and the vehicle seat
that is closest to the child’s head. You may need to
rotate the handle further down to the “stand”
position to provide enough room.


24
25

The level indicator must be completely green .
If you have fully adjusted the convenience base and
the level indicator is still not level, use a tightly rolled
towel or small blanket  beneath the front edge of
the base.
IMPORTANT: Infants may have difficulty breathing
when in a sitting position. Make sure they recline enough
for their head to lie back comfortably and safely. Failure
to properly recline the child restraint could increase the
child’s risk of serious injury or death.


7
You may rotate the handle to the farthest
position behind the restraint for more
room in small vehicles.
TIP!
TIP!