After securing the infant, place the restraint into your
vehicle. Adjust the restraint so that the level line is
parallel with the vehicle floor.
Note: Generally, the center rear seating position is the
safest. This infant restraint MUST face the rear of
the vehicle.
Installing the Carrier without the
Convenience Base
1
28
29
4
LAP BELT
LAP AND
SHOULDER BELT
Route ONLY the lap portion of the vehicle seat belt
through the belt slots on the carrier.
In vehicles with a lap and shoulder belt , DO NOT
route the shoulder belt through the belt slots. Instead,
let it lay across the vehicle seat back, as shown.
Rotate the handle
to the down
position by
squeezing both
handle triggers .
2
You may rotate the handle to the farthest
position behind the restraint for more
room in small vehicles.
TIP!
TIP!
Lap/shoulder seat belt
combination that has a
buckle tongue that slides
freely along the belt
without locking into place
and is equipped with
an emergency locking
retractor (ELR).
Locking
Clip
Check your vehicle seat belt type.
If you have this type of seat
belt (below) in your vehicle,
you
MUST
install the carrier
using the locking clip (p. 40).
3
Some ELR vehicle belts can be switched so that they
lock when tightened.
Consult your vehicle owner’s manual before
installing the locking clip.
To Next Page
Loading...
