1. TAKE THE LEFT HAND DOOR (PART 9) AND ALIGN THE HOLE IN THE BOTTOM DOOR INFILL PANEL.
3. PUSH A 12MM x M5 SCREW (PART 15) THROUGH THE HOLE IN THE BOTTOM OF THE DOOR, THROUGH THE
SPACER AND THROUGH THE HOLE IN THE BOTTOM INFILL PANEL.
4. PLACE 1 x M5 WASHER (PART 23) AND 1 x M5 LOCK NUT (PART 20) ONTO THE M5 SCREW AND TIGHTEN.
VIEW "A"
ATTACHMENT OF THE DOORS TO THE CABINET
FLINDERS, NORFOLK & DAINTREE TROLLEY ASSEMBLY
I
9
10
ENLARGED VIEW TO SHOW
INFILL PANEL ROTATED
FINAL ASSEMBLED
VIEW
2. PLACE A DOOR HINGE SPACER (PART 21) BETWEEN THE DOOR AND THE INFILL PANEL.
20
23
21
15
20
23
21
15
5. FOR THE DOOR TOP, CAREFULLY PLACE A DOOR HINGE SPACER BETWEEN THE DOOR AND THE TOP INFILL
PANEL. NOTE: IF IT IS A TIGHT FIT, ROTATE THE PANEL SLIGHTLY (SEE VIEW "A" ABOVE).
6. PUSH A 12MM x M5 SCREW (PART 15) THROUGH THE HOLE IN THE TOP OF THE DOOR, THROUGH THE
SPACER AND THROUGH THE HOLE IN THE TOP INFILL PANEL. NOTE: THE PANEL CAN NOW BE ROTATED BACK.
7. PLACE 1 x M5 WASHER (PART 23) AND 1 x M5 LOCK NUT (PART 20) ONTO THE M5 SCREW BUT DON'T TIGHTEN.
8. REPEAT STEPS 1-7 FOR THE RIGHT HAND DOOR (PART 10). FULLY TIGHTEN ALL OF THE NUTS AND SCREWS
ON THE DOOR TOPS AND THE TOP INFILL PANEL.
22
To Next Page
Loading...
