CLEANING & STORAGE
EXTERNAL CLEANING
Before cleaning the barbeque exterior and pedestal, ensure the appliance has cooled and
is safe to touch, and that the appliance has been removed from the power supply. Painted
and plastic surfaces can be cleaned using a mild household detergent or cleaner and a
clean cloth (do not use scourers or harsh detergents). It is advisable to test cleaners on
a small section of the appliance rst. NEVER use paint thinners or similar solvents for
cleaning and NEVER pour cold water over hot surfaces. Dry the surface afterwards.
Rotisserie poles should be wiped down with a soft cloth to remove any oil or grit (do not
allow water to ow down the poles and into the barbeque).
INTERNAL CLEANING
Before cleaning the internal parts of your barbeque, ensure the appliance has cooled and
is safe to touch. The inside of the charcoal chamber can be cleaned by using some water,
mild detergent and a sponge or mild scouring pad.
For hard to clean areas, use a little baking soda on a wet sponge. Do not use abrasive cleaners.
All ash and any leftover fuel should be removed after every use (take care that it is fully
extinguished and cold). After cleaning the charcoal chamber, remove the charcoal grid and
carefully twist the element upwards. Remove the element bracket (X) and remove and empty
the heat shield. Clean any ash or oil that may have dropped into the element bowl, and replace
the heat shield and element bracket. Twist the element back over the bracket and replace the
charcoal grid. Note: all parts MUST be in place correctly before cooking again.
WARNING! The surfaces of the open grills may be hot. Please ensure heat resistant
gloves are worn.
STORAGE
When the appliance is not in use, the barbeque (and pedestal if supplied) can be stored
outdoors, but must be under cover and covered (preferably with a purpose made FUSION
TM
Barbeque cover), out of the weather. Ensure the cooking surface is clean before storing away.
Do not leave the power cord connected to the power supply for extended periods of time
(disconnect after use).
To Next Page
Loading...
