Everdure FUSION - Step 14: Power Connection; Maintenance

17
Assembly, Operation & Maintenance Instructions
STEP 14
/ With the barbeque in a secure position, fully extend the power cord from the recess on the
right hand side (do not over-extend) and connect to your power supply.
*Due to ongoing design modications, support brackets may be permanently xed to the element
MAINTENANCE
It is recommended that at the commencement of each barbeque season the following
maintenance be conducted:
BARBEQUE
1. Wipe over the outer areas of the barbeque with a clean cloth.
2. Check all oils and ash have been cleaned from the charcoal chamber and under the
element.
3. Check all fasteners for tightness and re-tighten where necessary to ensure rigidity of
the structure.
4. Check retractable power cord is operational and the cord/plug is undamaged.
PEDESTAL
1. Check all fasteners for tightness and re-tighten where necessary to ensure rigidity of
the structure.
2. Wipe over barbeque pedestal with a clean cloth.
Wear and tear to this barbeque can be reduced by covering and storing out of the
weather when not in use.