83
Exterior Equipment
11.4 Leaning Post & Console
Aluminum Leaning Post
The leaning post/seat is made of welded powder
coated aluminum. The base accommodates a
large cooler that is secured with special brackets
and straps. Grab rails on the rear provide a hand-
hold for passengers.
THE COOLER COULD SLIDE UNEXPECTEDLY WHILE
UNDERWAY CAUSING DAMAGE TO THE BOAT OR INJURY TO
A PASSENGER SITTING ON THE COOLER SEAT IF IT IS NOT
SECURED PROPERLY. ALWAYS MAKE SURE THE COOLER IS
SECURED PROPERLY IN THE BRACKETS WITH THE STRAPS
BEFORE OPERATING THE BOAT.
The helm and passenger seat is equipped with
a ip up bolster to provide more room between
the seat and the helm. The bolster converts the
seat to a leaning post style seat with a backrest,
allowing the operator and passenger to sit or
stand at the helm. A powder coated footrest
automatically folds out when the bolster is folded
to the seat position. Gas springs connected to the
linkage between the footrest and bolster secure
the bolster in the leaning post or seat positions.
To convert the seat to a leaning post, lift the front
of the seat cushion to raise the bolster and push
it back above the seat cushion. The leaning post
footrest automatically folds to the leaning post
frame as the bolster is raised. Another molded
in footrest on the rear of the console can be used
when the bolsters are set to either position.
Bolster in Leaning Post Position
Cooler Sliding Bracket and Hold Down Strap
The re extinguisher mount is located below the
footrest on the rear of the console. The mounting
location keeps the re extinguisher out of the way
and readily available.
Leaning Post Baitwell (Optional)
A leaning post/baitwell can be installed as optional
equipment. The baitwell is equipped with a pump,
light, overow tting, drain and supply valve.
The clear acrylic baitwell hatch is equipped with
a “push to close” latch that secures the hatch in
the closed position. The baitwell drains by gravity
to a thru-hull tting in the hull.
Bolster in Seat Position
To Next Page
Loading...
