Evinrude E-TEC 300 - Page 391

I–5
INDEX
Servicing 177
Tests 173
P
Packard Connector Servicing 125
Pinion Gear
Bearing Installation 301
Bearing Removal 300
Installation 311
Removal 296
Piston Rings
End Gap 232
Inspection 227
Installation 232
Removal 222
Pistons
Assembly 231
Inspection 227
Installation 232
Removal 221
Powerhead
Assembly 228
Cleaning 225
Cylinder Compression Testing 216
Disassembly 219
Inspection 226
Installation 239
Removal 217
Views 242
Predelivery Checks 32
Pre-Season Service 46
Pressure Relief Valve, Cooling System 192
Priming
Fuel System 138
Oiling System 170
Propeller
Inspection 284
Installation 285
Selection 284
Propeller Shaft
Installation 310, 327
Lubrication 37
Removal 298
Propeller Shaft Bearing Housing
Bearing Installation 307
Bearing Removal 306
Installation 313
Rear Seal Installation 308
Rear Seal Removal 306
Propeller Shaft Bearing Housing, Counter
Rotation
Assembly 323
Installation 327
Propeller Shaft, Counter Rotation
Removal 318
R
Relays
Trim and Tilt 105
Remote Controls
Cable Adjustment 20
Cable Installation 19
Rigging
Outboard 17
RPM Limit 59, 61
S
S.A.F.E.
Description 63
Oil Pressure 59
Temperature 56, 58
Voltage 56
Sensors 94
Air Temperature Sensor 58, 95
Barometric Pressure Sensor 57
Crankshaft Position Sensor 60, 81, 94
I 56
Engine Temperature Sensor 58, 95, 191
Exhaust Pressure Sensor 42, 57
Knock sensor 61, 95
Oil Pressure 59, 165
Tests 94
Throttle Position Sensor 59, 94, 113
Service Charts
Electrical and Ignition 88
Fuel System 128
Gearcase 280
ICON Remote Control System 194
Midsection 258
Oiling System 156
Powerhead 214
Trim and Tilt 330