19
X OIL AND FUEL
FUEL SYSTEM OPERATION
Connecting the Fuel Hose
Connect the fuel hose to the connector.
If equipped, open vent screw on fuel tank’s fill-
er cap.
Squeeze fuel primer bulb, outlet end up, until
firm.
1. Fuel fitting
IMPORTANT: Fuel distribution hoses in the
boat must deliver fuel at the rate of flow need-
ed by the outboard. Minimum inside diameter
of fuel hoses must be 5/16 in. (7.9 mm).
Fuel systems with built-in tanks, particularly
those that include antisiphon valves and filter/
primer units, may have restrictions not allow-
ing the engine fuel pump to deliver sufficient
fuel under all conditions. This can result in a
loss of performance. If a performance prob-
lem exists, see your Dealer.
FUEL SYSTEM PRIMING
FUEL ADDITIVES
The only fuel additives approved for use in
your Evinrude E-TEC outboard are:
• Evinrude/Johnson 2+4 Fuel Conditioner
• Evinrude/Johnson Fuel System Cleaner
Use of other fuel additives can result in
poor performance or engine damage.
Evinrude/Johnson 2+4 Fuel Conditioner will
help prevent gum and varnish deposits from
forming in fuel system components and will
remove moisture from the fuel system. It can
be used continuously and should be used
during any period when the outboard is not
being operated on a regular basis. Its use will
reduce spark plug fouling, fuel system icing,
and fuel system component deterioration.
Evinrude/Johnson Fuel System Cleaner will
help keep fuel injectors in optimal operating
condition.
WARNING
Store fuel tanks in a well-ventilated
area, away from heat and open flame.
Prevent escape of liquid or vapors
which could accidentally ignite.
Close the filler cap vent screw, if
equipped.
Be sure the disconnected fuel hose
does not drip.
1
007004
If the outboard is run out of fuel, refill the fuel
tank and squeeze the primer bulb until firm.
Prime the electric fuel pump by first removing
the emergency stop switch clip and then pull-
ing the rope at least two times. This will cause
the fuel pump to fill the injectors. Replace the
emergency stop switch clip and follow the
normal starting procedure.
To Next Page
Loading...
