27
X OPERATION
TILLER HANDLE ADJUSTMENTS
IDLE SPEED CONTROL
Tiller models feature Troll Control™ which al-
lows adjusting the idle speed for trolling. The
default idle speed is 700 rpm. Press the + of
the button to increase or press the – side of
the button to decrease idle.
Idle speed may be adjusted up to 1500 rpm,
or down to 550 rpm.
If the engine is shut off, it will return to the de-
fault idle speed when restarted.
1. Troll Control button
TILLER HANDLE RATCHET
Tiller models feature a ratchet which holds the
tiller arm at approximately 30° or 90° posi-
tions. To release the tiller arm, press up on
the release lever.
1. Release lever
TILLER HANDLE ANGLE
Tiller handle angle can be raised or lowered
by turning the adjustment screw under the
handle.
1. Adjustment screw
TRIM/TILT SWITCH
If equipped, the trim/tilt switch is located in the
end of tiller handle. Press switch as indicated
for UP and DOWN operation.
1. Trim/tilt switch UP
2. Trim/tilt switch DOWN
Continue to “Fuel Economy” on page 30
1
007018
1
007019
1
007020
1
2
005107
To Next Page
Loading...
