EvoHeat Evo270 Hot Water Heat Pump Manual
6.9 Hydropower Setting
The Hydroboost heater can be turned on when the unit is heating or on standby.
Press once to turn on the Hydroboost heater and press again to shut it off.
6.10 Using Fan Mode
Press and hold for 2 seconds for the first time to change the fan mode to low speed running. The fan will run at
low speed when the unit’s target temperature is reached. Press and hold for 2 seconds again to change the fan
mode to high speed running, where it will run at high speed when the target temperature is reached. Press and
hold for 2 seconds for a third time to change the fan mode to shut-down and the fan will stop running when the
unit’s target temperature is reached.
To Next Page
Loading...
