EvoHeat Evo270 Hot Water Heat Pump Manual
8.7 Using the Overheating Protector
The overheating protector is used to turn the power off, preventing the hot water from being heated too high. To
return the unit to its normal operational status it will have to be re set manually. Please contact EvoHeat for a
service if this occurs.
OPERATION DETAILS
To access the overheat protector the front dark grey controller panel must be removed.
Remove the 3 screws on the front panel and push the front cover upwards.
Then remove the screws covering the overheat protector panel as below:
8.8 Draining the Water Tank
1. Close the cold-water inlet valve into the Evo 270.
2. Open a hot water tap inside the premises.
3. Undo the drain plug on the base of the unit to drain the water from the system.
CAUTION: THE WATER FROM THE HOT WATER TAP AND THE DRAIN PLUG WILL BE HOT.
BE CAREFUL OF BURNS AND SCALDS. WEAR PROTECTIVE CLOTHING
To Next Page
Loading...
