EvoHeat Evo270 Hot Water Heat Pump Manual
1. Introduction
This manual includes all the necessary information regarding the installation, operation and maintenance of the Evo
270.
The EVO 270 is the next evolution in water heating, with advanced energy efficiency technologies and built in smart
features to ensure you’re provided with clean, safe, and economical hot water all year round. Unlike traditional hot
water systems that use 1kW of energy to produce 1kW of heat, the EVO 270 utilises that very same 1kW of energy
and heat pump technology to generate 4kW of heat – saving you up to 75% of your hot water costs!
- When installing the Evo 270, follow all instructions as documented in this manual.
- Once the installation is complete, check that all connections are secure before the power is turned on.
- The installer is to explain to the end user how to operate and maintain the unit in accordance with this
instruction manual.
- Evo Industries Australia Pty Ltd will not be held responsible for any damages or injuries caused by the
incorrect installation of this hot water system.
- A maintenance programme must be carried out as recommended in this manual to ensure ongoing
reliability.
- Failure to comply with these recommendations could void the warranty and cause injury or death.
- Due to continuous product improvement, this manual may be subject to change without prior notice.
Smart and Efficient
The operational costs can be up to 75% less than that of
an electric water heater and can be installed in
locations which are unsuitable for solar hot water
heating.
Safe and Environmentally Friendly
Produce no harmful gases along or open flames making
the unit safe to work with when installing.
Easy to Operate
Featuring an easy to use timer for both start and stop
operations, with a controller to set the desired water
temperature.
2. Safety Precautions
A qualified technician is required to install, relocate the unit if required and for all repairs.
Good earthing is required for both the unit and power connections to prevent electrical shock.
Ensure that there are no leaks on both the plumbing and drainage fittings.
The unit must not be installed near flammable gas or have flammable aerosols sprayed in the vicinity.
The base that the unit is installed on must be level and stable.
A circuit breaker is required to be installed with this unit.
Fingers and objects must not be placed into the fan of the unit. Children should be kept clear of the
appliance.
In the event of the unit malfunctioning, shut off the power supply and contact your supplier or EvoHeat.
Power the unit off during cleaning.
The unit produces hot water and will also have hot fittings, therefore should not be touched to avoid injury.
To Next Page
Loading...
