KC PRIME
23
Please note the "T" shaped card must be used immediately after its bag is opened.
If the terminal is in a dusty environment, we recommend that you place a protective cover on the printer to limit exposure to dust, whether the printer
is in operational mode or not. For more thorough cleaning, you can also carry out manual cleaning.
The cleaning frequencies recommended by Evolis may be increased depending on the environment in which the terminal is located.
9 Remove the film from the adhesive card
1
and insert the cleaning card into the feeder as shown, adhesive side up
2
.
Cleaningstarts.
10 Remove the cleaning card from the output hopper.
11 Put the 200-card feeder extension back on the upper feeder part.
12 Adjust the card thickness. Please wait for 2 minutes before using your printer again.
9
10
11
12
To Next Page
Loading...
Need help?
General
