Evolution RAGE5-S User Manual

10
www.evolutionpowertools.com
• Hold the work rmly. Against the mitre
gauge or rip fence.
• Always use a push stick. Especially when
rip cutting narrow stock.
• Keep guards in place and in working
order. Always ensure that the riving knife
is tted and correctly adjusted. Inspect the
riving knife regularly and replace it if it is
worn. Use only a genuine Evolution riving
knife as this is a dedicated component for
this machine.
• Remove adjusting keys and wrenches.
Form the habit of checking to see that keys
and adjusting wrenches are removed from
the machine before turning it on.
• Do not use in a dangerous
environment. Do not use power tools in
damp or wet locations, or expose them to
rain. Keep work area well lit. Keep the area
well ventilated.
• Keep children away. All children and
visitors should be kept at a safe distance
from the work area.
• Do not use High Speed Steel (HSS)
blades. Ensure that the correct blade is
selected for the material being cut.
• The push stick or push block should
always be stored with the machine
when not in use.
• Connect the saw to a dust collection
device when sawing wood. The operator
should be informed of the factors that
inuenceexposuretoduste.g.typeof
material being cut and the importance of
local extraction (capture or source) and the
proper adjustment hoods/baes/chutes.
• Use a proper extension cord. Make sure
any extension cord is in good condition.
When using an extension cord, be sure to
use one heavy enough to carry the current
your machine will draw. An undersized cord
will cause a drop in line voltage resulting in
loss of power and possible overheating.
• Always use safety glasses. Also use a
face or dust mask if the cutting operation is
dusty. Everyday eyeglasses only have impact
resistant lenses, they are NOT safety glasses.
• Maintain tools with care. Keep tools
sharp and clean for best and safest
performance. Follow instructions for
lubricating and changing accessories.
• Disconnect from the power supply
before servicing, cleaning and/or when
changing accessories, such as blades.
• Use recommended accessories.
Only use genuine Evolution accessories.
• Check for damaged parts. Before further
use of the tool, a guard or other part that is
damaged should be carefully checked to
determine that it will operate properly and
perform its intended function - check for
alignment of moving parts, binding of moving
parts, breakage of parts, mounting, and any
other conditions that may aect its operation.
A guard or other part that is damaged should
be properly repaired or replaced.
• Keep hands out of the path of the
saw blade.
• Never reach around the saw blade.
• Turn o machine and wait for saw
blade to stop before making any
fence adjustments.
• Never pull or carry the tool by the
power cord. Carrying or pulling the tool by
the power cord could cause damage to the
insulation or the wire connections resulting
in the possibility of electric shock or re.
• When transporting the machine use
a transportation device. Never use the
guards for handling or transportation.
• During transportation the upper part
of the saw blade must be lowered fully
and covered by the guard.
• All operators using this machine must
read the instructions and familiarize
themselves with the machines workings.
• Never leave the saw running and
unattended. Do not leave the saw until
the saw has been switched OFF, and the
blade has come to a complete halt.

Evolution RAGE5-S Specifications

General

Motor Power	1500 W
Bevel Capacity	45 degrees
Bore	25.4 mm
Mild Steel Capacity (Wall Thickness)	6 mm
Voltage	230 V
Frequency	50 Hz